GS 300 RWD V6-3.0L (3GR-FSE) (2006)
/Page-1131008.png)
2. INSTALL PROPELLER SHAFT ASSEMBLY
a. Align the matchmarks on the intermediate shaft flange and the propeller shaft flange, and install the shaft with the 4 bolts, washers and nuts.
Torque: 74 Nm (750 kgf-cm, 54 ft. lbs.)
INSTALLATION
1. INSTALL REAR PROPELLER SHAFT ASSEMBLY
a. Remove the SST from the transmission.
SST 09325-40010
b. Insert the yoke of the intermediate shaft into the transmission.
HINT: Be careful not to damage the oil seal.
c. Install the 2 center support bearing washers and center support bearing, and temporarily tighten the 2 bolts.
