GS 300 RWD V6-3.0L (3GR-FSE) (2006)
3. REMOVE FRONT AXLE HUB NUT
a. Using SST and a hammer, release the staked part of the front axle hub nut.
SST 09930-00010
NOTICE: Release the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
b. While applying the brakes, remove the front axle hub nut.
4. SEPARATE LOWER BALL JOINT ASSEMBLY FRONT
a. Remove the 2 bolts and steering knuckle from the lower ball joint.
5. SEPARATE TIE ROD ASSEMBLY
a. Remove the clip and nut.
b. Using SST, separate the tie rod end from the steering knuckle.
SST 09628-00011
NOTICE:
^
Pay careful attention not to damage the steering knuckle because it is made of aluminum and may be damaged easily.
^
Do not damage the ball joint dust cover.
^
Make sure that the SST is securely set to the steering knuckle spacer.
^
If the steering knuckle spacer has come off, replace the steering knuckle with a new one.