GS 300 RWD V6-3.0L (3GR-FSE) (2006)
f.
Align the matchmarks and install the inboard joint assembly to the outboard joint shaft assembly.
9. INSTALL INBOARD JOINT BOOT
a. Install the inboard joint boot to the inboard joint assembly.
10. INSTALL FRONT AXLE INBOARD JOINT BOOT LH CLAMP
a. Using a screwdriver, install the inboard joint boot clamp as shown in the illustration.
11. INSTALL FRONT AXLE INBOARD JOINT BOOT LH NO. 2 CLAMP
a. Using a screwdriver, install the inboard joint boot clamp No. 2 as shown in the illustration.
12. INSPECT DRIVE SHAFT
a. Check that there is no excessive play in the outboard joint.
b. Check that the inboard joint slides smoothly in the thrust direction.
c. Check that there is no excessive play in the radial directions of the inboard joint.
INSTALLATION
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
a. Coat the spline of the inboard joint shaft assembly with gear oil.
b. Set the shaft snap ring with the opening side facing down.