GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Steering Angle Sensor: Service and Repair
Installation
BRAKE CONTROL: STEERING ANGLE SENSOR: INSTALLATION
INSTALLATION
1. INSTALL STEERING SENSOR
(a) Align the locating pins, engage the claws and install the steering sensor to the spiral cable sub-assembly
2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING SENSOR See: Restraint Systems/Air Bag Systems/Clockspring Assembly /
Spiral Cable/Service and Repair/Installation
3. INSTALL STEERING COLUMN COVER
for 2GR-FSE See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and Replacement/Installation
for 1UR-FSE See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and Replacement/Installation
4. CENTER SPIRAL CABLE See: Restraint Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Installation
5. INSTALL STEERING WHEEL ASSEMBLY
for 2GR-FSE See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and Replacement/Installation
for 1UR-FSE See: Steering and Suspension/Steering/Steering Column/Service and Repair/Removal and Replacement/Installation
6. INSTALL HORN BUTTON ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
7. INSPECT STEERING WHEEL CENTER POINT
8. CONNECT BATTERY NEGATIVE TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Programming
and Relearning.
9. INSPECT HORN BUTTON ASSEMBLY See: Restraint Systems/Air Bag Systems/Air Bag/Service and Repair/Steering Pad/Installation
10. INSPECT SRS WARNING LIGHT
See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System