GS 350 AWD V6-3.5L (2GR-FSE) (2009)
/Page-726001.png)
Variable Valve Timing Actuator Position Sensor: Service and Repair
Removal
2GR-FSE ENGINE CONTROL SYSTEM: VVT SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE V-BANK COVER See: Service and Repair/Removal and Replacement/Engine Assembly/Removal
3. REMOVE VVT SENSOR (for Intake Side of Bank 1)
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
5. REMOVE VVT SENSOR (for Intake Side of Bank 2)
(a) Disconnect the sensor connector.
(b) Remove the bolt and sensor.
6. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)
