GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Oil Filter: Service and Repair
Replacement
2GR-FSE LUBRICATION: OIL AND OIL FILTER (for 4WD): REPLACEMENT
REPLACEMENT
CAUTION:
-
Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness,
irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
-
Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil.
Protective clothing and gloves that cannot be penetrated by oil should be worn. The skin should be washed with soap and water,
or use waterless hand cleaner, to remove any used engine oil thoroughly. Do not use gasoline, thinners, or solvents.
-
In order to protect the environment, used oil and used oil filters must be disposed of at designated disposal sites.
1. REMOVE OIL FILTER ELEMENT SERVICE HOLE COVER
(a) Remove the screw and clip, and open the service hole cover.
2. REMOVE OIL FILLER CAP SUB-ASSEMBLY
3. DRAIN ENGINE OIL
(a) Remove the drain plug and gasket.
(b) Drain the oil into a container.
(c) Install a new gasket and the drain plug.
Torque: 40 Nm (408 kgf-cm, 30 ft-lbf)
4. REMOVE OIL FILTER ELEMENT
(a) Connect a hose with an inside diameter of 15 mm (0.59 in.) to the oil filter drain pipe.