GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Secondary Injector Control Module: Service and Repair
Removal
2GR-FSE FUEL: INJECTOR DRIVER: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
3. REMOVE NO. 1 AIR CLEANER INLET
(a) Remove the bolt and No. 1 air cleaner inlet.
4. REMOVE NO. 1 ENGINE COVER
(a) Remove the clip, 2 cap nuts and cover.
5. REMOVE INJECTOR DRIVER
(a) Disconnect the 4 injector driver connectors.
(1) Move the lock lever in the direction indicated by the arrow to release the connector lock. Disconnect the 3 connectors with wire harness
locks and the connector from the injector driver.