GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Air Bag Control Module: Service and Repair
Removal
SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
2. REMOVE CONSOLE UPPER PANEL GARNISH FRONT See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
3. REMOVE FRONT ASH RECEPTACLE ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
4. REMOVE INSTRUMENT PANEL FINISH LH PANEL END See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal
5. REMOVE INSTRUMENT PANEL FINISH RH PANEL END See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal
6. REMOVE CONSOLE BOX PLATE See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
7. REMOVE CONSOLE BOX REGISTER ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
8. REMOVE CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Removal
9. REMOVE CENTER AIRBAG SENSOR ASSEMBLY
(a) Disconnect the holder (with connectors).
(b) Remove the nut, 2 bolts and center airbag sensor.