GS 350 AWD V6-3.5L (2GR-FSE) (2009)
/Page-2178007.png)
8. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Remove the bolt.
(b) Rotate the adjuster approximately 90°.Then pull and remove it.
Installation
SEAT BELT: FRONT SEAT OUTER BELT ASSEMBLY: INSTALLATION
INSTALLATION
HINT: The installation procedures are the removal procedures in reverse order.
1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(a) Insert the tip of the adjuster into the pillar, and align the adjuster's bolt hole to the pillar's bolt hole.
(b) Install the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
(a) Install the seat belt with the 2 bolts. First install the upper bolt, and then install the lower bolt.
Torque: 7.5 Nm (77 kgf-cm, 66 in-lbf)
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
(b) Connect the pretensioner connector labeled A, as show in the illustration.
(c) Connect the tension reducer connector labeled B.
(d) Connect the pre-collision safety connector labeled C.
