lexus Workshop Repair Guides

Lexus Workshop Service and Repair Manuals

Center Airbag Sensor Assembly|Page 7612 > < Center Airbag Sensor Assembly|Page 7610
Page 2
background image

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

2. REMOVE REAR SEAT CUSHION ASSEMBLY See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly/Removal
3. REMOVE REAR SEAT LH AND RH HEADREST ASSEMBLY
4. REMOVE REAR SEATBACK ASSEMBLY See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly/Removal
5. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
6. REMOVE REAR SEAT SIDE GARNISH (w/o REAR SEAT AIRBAG ASSEMBLY) See: Body and Frame/Interior Moulding /

Trim/Headliner/Service and Repair/Removal

7. REMOVE REAR SEAT SIDE AIRBAG ASSEMBLY (w/ REAR SEAT AIRBAG ASSEMBLY) See: Air Bag Systems/Air Bag/Service and

Repair/Rear Seat Side Airbag Assembly/Removal

8. REMOVE REAR AIRBAG SENSOR

(a) Disconnect the connector.
(b) Remove the bolt, nut and rear airbag sensor.

Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR: INSTALLATION

INSTALLATION

1. INSTALL REAR AIRBAG SENSOR

(a) Check that the engine switch is off.
(b) Check that the battery negative (-) terminal is disconnected.

CAUTION:
After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.

(c) Install the rear airbag sensor with the nut and bolt.

Torque: 18 Nm (184 kgf-cm, 13 ft-lbf)

-

If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector,
replace it with a new one.

-

When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.
(e) Connect the connector.

2. INSTALL REAR SEAT SIDE GARNISH (w/o REAR SEAT AIRBAG ASSEMBLY) See: Body and Frame/Interior Moulding /

Trim/Headliner/Service and Repair/Installation

3. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY (w/ REAR SEAT AIRBAG ASSEMBLY) See: Air Bag Systems/Air Bag/Service and

Repair/Rear Seat Side Airbag Assembly/Installation

Center Airbag Sensor Assembly|Page 7612 > < Center Airbag Sensor Assembly|Page 7610