GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Power Mirror Switch: Service and Repair
Installation
MIRROR: OUTER MIRROR SWITCH: INSTALLATION
INSTALLATION
1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY
(a) Connect each connector.
(b) Attach the 2 claws to install the control panel.
(c) Install the 2 screws.
2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Installation
4. INSTALL INSTRUMENT SIDE PANEL LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
5. INSTALL FRONT DOOR OPENING TRIM COVER LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
6. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair/Installation
8. INSTALL CONSOLE UPPER PANEL ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Installation
9. INSTALL FRONT CONSOLE UPPER PANEL GARNISH See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning.
NOTE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
12. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Diagnosis System.