GS 350 AWD V6-3.5L (2GR-FSE) (2009)
/Page-1663007.png)
(a) Adjust the shift lever position See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Shifter A/T/Adjustments/AA80E
Automatic Transmission.
5. INSTALL REAR PROPELLER SHAFT ASSEMBLY See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Rear Propeller Shaft Assembly/Installation
6. FULLY TIGHTEN NO. 1 CENTER SUPPORT BEARING ASSEMBLY See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Rear Propeller Shaft Assembly/Installation
7. INSPECT AND ADJUST NO. 2 AND NO. 3 JOINT ANGLE See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Rear Propeller Shaft Assembly/Installation
8. INSTALL AIR GUIDE PLATE OUTSIDE RH See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Rear Propeller Shaft Assembly/Installation
9. INSTALL FRONT FLOOR NO. 1 HEAT INSULATOR See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair/Rear Propeller Shaft Assembly/Installation
10. INSTALL FRONT EXHAUST PIPE ASSEMBLY See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
11. CONNECT HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
12. CONNECT HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
13. INSTALL FRONT FLOOR COVER CENTER LH
14. INSTALL FRONT FLOOR COVER CENTER RH
15. INSTALL FRONT CENTER FLOOR BRACE See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and Repair/Installation
16. INSTALL REAR NO. 1 FLOOR PANEL BRACE See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Pipe/Service and
Repair/Installation
17. INSTALL NO. 2 ENGINE UNDER COVER
18. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
(a) Inspect the switch See: Testing and Inspection/AA80E Automatic Transmission/On-Vehicle Inspection.
19. INSPECT FOR EXHAUST GAS LEAK
