GS 350 AWD V6-3.5L (2GR-FSE) (2009)
(a) Check the harness and the connectors between the park/neutral position switch and the starter relay.
(1) Disconnect the E77 PNP switch connector.
(2) Remove the STARTER relay from the engine room No. 1 relay block.
(3) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
Standard resistance (Check for short):
(b) Check the harness and the connector between the starter relay and the body ground.
(1) Remove the STARTER relay from the engine room No. 1 relay block.
(2) Measure the resistance according to the value(s) in the table below.
Standard resistance (Check for open):
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
8. INSPECT ENGINE ROOM RELAY BLOCK (STARTER RELAY VOLTAGE)