GS 350 AWD V6-3.5L (2GR-FSE) (2009)
(d) Install the upper bead.
NOTE:
Make sure that the tire bead and tool do not interfere with the main body of the sensor and that the sensor is not clamped by the bead.
(e) Inflate the tire. If the valve nut is loose, retighten the nut to the specified torque and then check for air leaks with soapy water.
Torque: 4.0 Nm (41 kgf-cm, 35 in-lbf)
NOTE:
No apply after tightening with specified torque.
2. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
3. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
4. INSPECT TIRE
(a) Inspect the tire See: Wheels and Tires/Testing and Inspection/Component Tests and General Diagnostics.
5. REGISTER TRANSMITTER ID
HINT:
See: Wheels and Tires/Tire Monitoring System/Testing and Inspection/Programming and Relearning/Registration.
6. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT:
See: Wheels and Tires/Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Test Mode Procedure.