GS 350 AWD V6-3.5L (2GR-FSE) (2009)
/Page-1885004.png)
A. Disconnect the connector.
B. Remove the three bolts.
C. Repeat the procedure on the opposite side.
10. Separate the front height control sensor link sub-assembly.
A. Remove the nut and separate the height control sensor link.
B. Repeat the procedure on the opposite side.
11. Separate the front lower ball joint assembly.
A. Remove the two bolts and separate the front lower ball joint assembly
B. Repeat the procedure on the opposite side.
12. Separate the tie rod assembly.
A. Remove the clip and nut.
