GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Control Module: Service and Repair
Removal
AA80E AUTOMATIC TRANSMISSION: TCM: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and Inspection/Programming
and Relearning.
2. REMOVE COOL AIR INTAKE DUCT SEAL See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
3. REMOVE ENGINE ROOM SIDE COVER LH See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Assembly/Removal
4. REMOVE ENGINE ROOM ECU COVER See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal and Replacement/Removal
5. DISCONNECT WIRE HARNESS See: Powertrain Management/Computers and Control Systems/Engine Control Module/Service and
Repair/Removal and Replacement/Removal
6. REMOVE TCM
(a) Disconnect the 2 connectors.
(b) Remove the 2 nuts and TCM.