GS 350 AWD V6-3.5L (2GR-FSE) (2009)
NOTE:
Put identification marks on the case bearing outer race to distinguish between the RH side and LH side.
23. REMOVE DIFFERENTIAL RING GEAR
(a) Hold the differential case in a vise between aluminum plates.
NOTE:
Do not overtighten the vise.
(b) Put matchmarks on the ring gear and differential case.
(c) Using a screwdriver and a hammer, unstake the 4 lock plates.
(d) Remove the 8 ring gear set bolts and 4 lock plates.
(e) Using a plastic hammer, tap on the ring gear to separate it from the differential case.
24. REMOVE FRONT DIFFERENTIAL CASE BEARING
HINT: Perform this procedure only when replacing the case bearing or differential case.
(a) Hold the differential case in a vise between aluminum plates.
NOTE:
Do not overtighten the vise.
(b) Using SST, remove the case bearing inner races LH and RH from the differential case.
SST: 09950-60010
09951-00390
SST: 09950-40011
09951-04020
09952-04010
09953-04030
09954-04010
09955-04061
09957-04010
09958-04011
NOTICE:
-
Do not deform the bearing cage if the bearing is to be reused.
-
Hook the SST claw from the dent of the differential case to the bearing inner race.
-
Apply grease to the threads and tip of the SST center bolt before use.