GS 350 AWD V6-3.5L (2GR-FSE) (2009)
Windshield Washer Motor: Service and Repair
Removal
WIPER AND WASHER: FRONT WASHER MOTOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE COOL AIR INTAKE DUCT SEAL See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
3. REMOVE ENGINE UNDER COVER (for 2WD) See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
4. REMOVE ENGINE UNDER COVER (for 4WD) See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal
5. REMOVE FRONT FENDER LINER LH
(a) Using a screwdriver, remove the 2 clips.
(b) Remove the 2 bolts and partially remove the fender liner.
HINT: It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover, windshield washer jar and pump can
be removed in a later step.
6. REMOVE FRONT FENDER LINER RH
(a) Using a screwdriver, remove the 2 clips and partially remove the fender liner.
HINT: It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed in a later step.
7. REMOVE FRONT BUMPER COVER See: Body and Frame/Bumper/Front Bumper/Service and Repair/Removal