GS 350 RWD V6-3.5L (2GR-FSE) (2007)
/Page-1200002.png)
SST 09520-00031 (09520-00040), 09521-00020, 09950-00020
NOTE:
-
Keep the sensor away from magnets.
-
Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
-
If the speed sensor rotor is damaged or deformed, replace the hub and bearing assembly.
-
Do not scratch the area where the skid control sensor contacts the hub and bearing assembly.
-
Do not attach foreign matter to the speed sensor rotor.
INSTALLATION
1. INSTALL SPEED SENSOR FRONT LH
a. Wipe off sealant attached to the skid control sensor's fitting surface with white gasoline.
NOTE: Prevent foreign matter from attaching to the sensor rotor.
b. Install a new skid control sensor to the hub and bearing assembly. The skid control sensor connector should be placed in the upper position.
c. Press the skid control sensor or the it becomes flat with the hub and bearing using the SST and press.
NOTE:
-
Keep the sensor away from magnets.
-
Do not use a hammer on the skid control sensor.
-
Check that there is no foreign matter such as iron chips on the skid control sensor's detecting portion.
-
Slowly press the skid control sensor straight.
2. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH
3. INSPECT FRONT AXLE HUB BEARING LOOSENESS
4. INSTALL FRONT AXLE HUB RUNOUT
5. INSTALL FRONT DISC
6. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH
7. CONNECT SPEED SENSOR FRONT LH
