GS 350 RWD V6-3.5L (2GR-FSE) (2007)
2.
Remove the cool air intake duct seal by removing the 7 clips.
3.
Remove the engine compartment side cover RH by removing the 2 clips.
4.
Remove the engine compartment side cover LH by removing the 3 clips.
5.
Remove the V-bank cover sub-assembly.
A.
Hold the front of the V-bank cover and raise it to disengage the 3 clips on the front of the cover.
B.
Continue to raise the cover to disengage the clip on the rear of the cover and remove the cover.
NOTE
Attempting to disengage the both the rear and front clips at the same time may cause the cover to break.