GS 350 RWD V6-3.5L (2GR-FSE) (2007)
4. Remove the 2 bolts between the LH/RH exhaust manifold and exhaust pipe (see Figures 3 and 4).
NOTICE
Make sure the wire harness for the 02 sensors is NOT pulled too tightly when the exhaust bolts are removed. The under-hoist stand is used to
prevent the harness from being pulled too tightly.
5. AWD Vehicles:
Remove the front propeller shaft.
Refer to the Technical Information System (TIS) applicable model and model year Repair Manual:
^
GS 300:
Drivetrain - Drive Shaft/Propeller Shaft - "Propeller Shaft: Front Propeller Shaft Assembly (for 4WD): Removal"
^
2006 GS 350:
Drivetrain - Drive Shaft/Propeller Shaft - "Propeller Shaft: Front Propeller Shaft Assembly (for 4WD): Removal"
^
2006 / 2007 IS 250:
Drivetrain - Drive Shaft/Propeller Shaft - "Propeller Shaft: Front Propeller Shaft Assembly (for 4WD): Removal"