GS 350 RWD V6-3.5L (2GR-FSE) (2007)
g. Hold SST with one hand and use SST to tighten the fuel pump gauge retainer 2 turns so that the starting mark on the retainer is within the
indicated range in the illustration.
h. Connect the fuel return tube.
1. Push the fuel tube joint in the plug of the fuel suction plate, then install the tube joint clip.
NOTE:
-
Check that there are no scratches or foreign matter around the connected parts of the fuel tube joint and plug before performing this
work.
-
Check that the fuel tube joint is securely inserted.
-
Check that the tube joint clip is on the collar of the fuel tube joint.
-
After installing the tube joint clip, check that the fuel tube cannot be pulled out.
25. INSTALL REAR FLOOR SERVICE HOLE COVER
a. Connect the fuel sender gauge connector.