GS 350 RWD V6-3.5L (2GR-FSE) (2007)
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
3. REMOVE FRONT SEAT ASSEMBLY
4. REMOVE FRONT DOOR SCUFF PLATE
5. REMOVE REAR DOOR SCUFF PLATE
6. REMOVE CENTER PILLAR GARNISH LOWER
7. REMOVE CENTER PILLAR GARNISH
a. Using a screwdriver, detach the 3 clips and claw, and remove the 2 screws and center pillar garnish.
HINT: Tape the screwdriver tip before use.
b. Pull out the outer belt anchor from the center pillar garnish.
8. REMOVE FRONT SEAT OUTER BELT ASSEMBLY
a. Remove the nut and shoulder anchor.
b. Disconnect the pretensioner connector as shown in the illustration labeled A.
c. Disconnect the tension reducer connector labeled B.
d. Disconnect the pre-collision safety connector labeled C.