GS 350 RWD V6-3.5L (2GR-FSE) (2007)
a. Detach the 2 claws and remove the trim lower cover.
b. Remove the screw.
c. Using a clip remover, detach the 9 clips and remove the trim cover.
d. Disconnect the 2 cables from the inside handle.
3. REMOVE SEAT MEMORY SWITCH LH
a. Disconnect the connector.
b. Remove the 2 screws and memory switch.
INSTALLATION
HINT:
-
Use the same procedures for the RH and LH side.
-
A bolt without a torque specification is shown in the standard bolt chart.