GS 350 RWD V6-3.5L (2GR-FSE) (2007)
c. Check that no codes other than ABS code 42, VSC code 45 and Electronically Controlled Brake System code 48, 66, or 95 are stored in the
diagnostic system.
HINT: The ABS warning light and multi-information display do not indicate the normal system code.
d. Remove SST from the terminals of the DLC3.
5. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR (WHEN USING SST CHECK WIRE:)
NOTE:
-
While obtaining the zero point, do not vibrate the vehicle by tilting, moving or shaking. Keep it in a stationary condition and do not start the
engine.
-
Choose a level surface with an inclination of less than 1°.
a. Procedures for Test Mode.
1. Turn the engine switch off.
2. Using SST, connect terminals TS and CG of the DLC3.