GS 350 RWD V6-3.5L (2GR-FSE) (2007)
Yaw Rate Sensor: Service and Repair
REMOVAL
1. REMOVE CONSOLE UPPER PANEL GARNISH FRONT
2. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY
3. REMOVE CONSOLE BOX PLATE
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
6. REMOVE CONSOLE BOX REGISTER ASSEMBLY
7. REMOVE CONSOLE BOX
8. REMOVE CONSOLE BOX NO.2 DUCT
a. Remove the 2 clips and the console box No.2 duct.
9. REMOVE CONSOLE BOX NO.1 DUCT
a. Remove the clip and the console box duct No. 1.
10. REMOVE YAW RATE SENSOR
a. Disconnect the yaw rate sensor connector.
b. Separate the 2 wire harness clamps.
c. Remove the 2 bolts and yaw rate sensor.
NOTE: Do not remove the sensor from the bracket.
INSTALLATION
1. INSTALL YAW RATE SENSOR