GS 350 RWD V6-3.5L (2GR-FSE) (2007)
a. Install the yaw rate sensor with the 2 bolts.
Torque: 15 N.m (153 kgf.cm, 11 ft.lbf)
NOTE:
-
Do not damage the yaw rate sensor.
-
Make sure that the yaw rate sensor is installed securely.
b. Install the 2 wire harness clamps.
c. Connect the yaw rate sensor connector.
2. INSTALL CONSOLE BOX NO.1 DUCT
a. Install the console box No. 1 duct with the clip.
3. INSTALL CONSOLE BOX NO.2 DUCT
a. Install the console box No.2 duct with the 2 clip.
4. INSTALL CONSOLE BOX
5. INSTALL CONSOLE BOX REGISTER ASSEMBLY
6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
8. INSTALL CONSOLE BOX PLATE
9. INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY
10. INSTALL CONSOLE UPPER PANEL GARNISH FRONT
11. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION. See: Acceleration/Deceleration Sensor/Testing and Inspection/Programming
and Relearning/Vehicle Stability Control System