GS 350 RWD V6-3.5L (2GR-FSE) (2007)
/Page-1225004.png)
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt
pretensioner activation.
2. REMOVE ENGINE UNDER COVER (for 2WD)
3. REMOVE ENGINE UNDER COVER (for 4WD)
4. REMOVE COOL AIR INTAKE DUCT SEAL
5. REMOVE ENGINE ROOM SIDE COVER LH
6. REMOVE ENGINE ROOM SIDE COVER RH
7. REMOVE V-BANK COVER
8. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
9. REMOVE NO. 1 AIR CLEANER INLET
10. DRAIN ENGINE COOLANT
11. REMOVE RADIATOR RESERVOIR ASSEMBLY
12. REMOVE V-RIBBED BELT
13. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
a. Remove the bolt, pulley cover plate and idler pulley.
14. REMOVE COMPRESSOR ASSEMBLY
a. Remove the compressor with pulley for 2WD or 4WD.
15. REMOVE GENERATOR ASSEMBLY
a. Detach the clamp, and remove the bolt from the generator.
b. Disconnect the generator connector.
c. Detach the rubber cap, and then remove the nut and battery cable.
