GS 350 RWD V6-3.5L (2GR-FSE) (2007)
b. Rotate the pinion gear clockwise, and check that it turns freely. Try to rotate the pinion gear counterclockwise and check that it locks.
If necessary, replace the center bearing clutch subassembly.
5. INSPECT REPAIR SERVICE STARTER KIT
a. Check the operation.
1. Push in the plunger, and then check that it returns quickly to its original position.
If necessary, replace the repair service starter kit.
b. Check the resistance.
1. Using an ohmmeter, measure the resistance between terminals 50 and C.
Standard resistance: Below 1 ohm
If the result is not as specified, replace the repair service starter kit.