GS 350 RWD V6-3.5L (2GR-FSE) (2007)
9. REMOVE STEERING KNUCKLE
a. Remove the clip and castle nut.
b. Using SST, remove the steering knuckle from the upper suspension arm.
SST 09628-00011
NOTICE:
^
Pay careful attention not to damage the steering knuckle because it is made of aluminum and may damage easily.
^
Do not damage the ball joint dust cover.
^
Make sure that the SST is securely set to the steering knuckle spacer.
^
If the steering knuckle spacer has come off, replace the steering knuckle with a new one.
^
Make sure that the string of the SST is securely tied to the vehicle.
10. SEPARATE LOWER BALL JOINT ASSEMBLY FRONT (for 2WD)
a. Remove the 2 bolts and steering knuckle from the lower ball joint.
INSTALLATION
1. INSTALL STEERING KNUCKLE
a. Install the steering knuckle to the upper suspension arm with a castle nut and new clip.
Torque: 87 Nm (887 kgf-cm, 64 ft. lbs.)