GS 350 RWD V6-3.5L (2GR-FSE) (2007)
COMPONENTS (Part 3)
REMOVAL
1. REMOVE NO. 2 ENGINE UNDER COVER
2. REMOVE FRONT FLOOR BRACE CENTER
3. REMOVE REAR FLOOR NO. 1 PANEL BRACE (for 3UZ-FE)
4. REMOVE HEATED OXYGEN SENSOR (for Sensor 2)
(a)
for 2GR-FSE:
Disconnect the sensor from the front exhaust pipe.
(b) for 3UZ-FE:
Disconnect the sensor from the front exhaust pipe.
5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2GR-FSE)
6. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 3UZ-FE)
7. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR
(a)
for 2GR-FSE:
Remove the 4 nuts, grommet and front floor No. 1 heat insulator.
(b) for 3UZ-FE:
Remove the 4 nuts and front floor No. 1 heat insulator.