GS 430 V8-4.3L (3UZ-FE) (2004)
HINT: Tape the scraper tip before use.
15. REMOVE WINDSHIELD GLASS
a. Disconnect the connector.
b. Push piano wire through between the body and glass from the interior.
c. Tie both wire ends to a wooden block or similar object.
HINT: Apply adhesive tape to the outer surface to keep the surface from being scratched.
d. Cut the adhesive by pulling the piano wire around it.
e. Remove the glass.
NOTE: Leave as much of the adhesive on the body as possible when cutting off the glass.
INSTALLATION
1. CLEAN AND SHAPE CONTACT SURFACE OF BODY
a. Using a knife, cut away any rough areas on the body.
HINT: Leave as much of the adhesive on the body as possible.
b. Clean the cutting surface of the adhesive with a piece of shop rag saturated in cleaner.
HINT: Even if all the adhesive has been removed, clean the body.