GS 460 V8-4.6L (1UR-FSE) (2008)
Acceleration/Deceleration Sensor: Service and Repair
Installation
BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: INSTALLATION
1. INSTALL YAW RATE SENSOR
(a) Install the yaw rate sensor with the 2 bolts.
Torque: 15 Nm (153 kgf-cm, 11 ft-lbf)
NOTICE:
-
Do not damage the yaw rate sensor.
-
Make sure that the yaw rate sensor is installed securely.
(b) Install the 2 wire harness clamps.
(c) Connect the yaw rate sensor connector.
2. INSTALL CONSOLE BOX NO.1 DUCT
(a) Install the console box No.1 duct with the clip.
3. INSTALL CONSOLE BOX NO.2 DUCT
(a) Install the console box No.2 duct with the 2 clip.
4. INSTALL CONSOLE BOX See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Installation
5. INSTALL CONSOLE BOX REGISTER ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Console/Service and Repair/Installation
6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Installation
7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Installation