GS 460 V8-4.6L (1UR-FSE) (2008)
Backup Lamp: Service and Repair
Removal
LIGHTING: REAR COMBINATION LIGHT ASSEMBLY: REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Removal
3. REMOVE TOOL BOX See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Removal
4. REMOVE REAR FLOOR FINISH PLATE See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and Repair/Removal
5. REMOVE LUGGAGE COMPARTMENT TRIM COVER SIDE RH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Removal
6. REMOVE LUGGAGE COMPARTMENT TRIM COVER SIDE LH See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Removal
7. REMOVE LUGGAGE COMPARTMENT TRIM COVER FRONT See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Service and
Repair/Removal
8. REMOVE REAR COMBINATION LIGHT ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 3 nuts and rear combination light.
(c) Remove the rear combination light bulb from the rear combination light socket and wire sub-assembly.
(d) Remove the gasket.
NOTICE:
-
Be sure to remove the gasket completely from the body.
-
Be sure to replace it with the supplied rear combination light gasket to prevent water intrusion.