GS 460 V8-4.6L (1UR-FSE) (2008)
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Removal
3. REMOVE REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Disassembly
4. REMOVE REAR AXLE HUB BOLT
(a) Using SST, and remove the rear axle hub bolt.
SST: 09628-10011
NOTICE:
Do not damage the threads of the hub bolts.
5. INSTALL REAR AXLE HUB BOLT
(a) Install a washer and nut to a new bolt as shown in the illustration.
(b) Using a screw driver or an equivalent to hold the hub & bearing assembly, install the rear axle hub bolt by tightening the nut.
NOTICE:
Do not damage the threads of the hub bolts.
6. INSTALL REAR DISC See: Brakes and Traction Control/Disc Brake System/Service and Repair/Rear Brake/Reassembly
7. ADJUST PARKING BRAKE SHOE CLEARANCE See: Brakes and Traction Control/Parking Brake System/Adjustments
8. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Service and Repair/Installation
9. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)