GS 460 V8-4.6L (1UR-FSE) (2008)
(a) Disconnect the absorber control ECU sub bus line connector (K78) from the P-CAN J/C B side (w/o earth terminal).
NOTICE:
-
Before disconnecting the connector, make a note of where it is connected.
-
Reconnect the connector to its original position.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
OK -- CONNECT CONNECTOR
NG -- Continue to next step.
Part 2
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Short in CAN Bus Lines - Continued
30. CONNECT CONNECTOR
(a) Reconnect the absorber control ECU sub bus line connector (K78) to the P-CAN J/C B side (w/o earth terminal).
NEXT -- Continue to next step.
31. CHECK CAN BUS LINES FOR SHORT CIRCUIT (POWER STEERING ECU SUB BUS LINE)
(a) Disconnect the power steering ECU sub bus line connector (K80) from the P-CAN J/C B side (w/o earth terminal).