GS 460 V8-4.6L (1UR-FSE) (2008)
/Page-2108003.png)
(3) Move the SST at least 10 m (33 ft) away from the vehicle rear side window.
(4) Maintaining enough clearance for the SST wire harness in the rear side window, close all doors and windows of the vehicle.
NOTICE:
Take care not to damage the SST wire harness.
(5) Connect the red clip of the SST to the battery positive (+) terminal and the black clip of the SST to the battery negative (-) terminal.
(f) Deploy the airbag.
(1) Check that no one is inside the vehicle or within a 10 m (33 ft) radius of the vehicle.
(2) Press the SST activation switch and deploy the airbag.
CAUTION:
-
When deploying the airbag, make sure that no one is near the vehicle.
-
The curtain shield airbag assembly becomes extremely hot when the airbag is deployed, so do not touch it for at least 30 minutes
after deployment.
-
Use gloves and safety glasses when handling a curtain shield airbag assembly with a deployed airbag.
-
Do not apply water, etc. to a curtain shield airbag assembly with a deployed airbag.
-
Always wash your hands with water after completing the operation.
HINT:
The airbag is deployed as the LED of the SST activation switch comes on.
2. DISPOSE OF CURTAIN SHIELD AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE)
NOTICE:
-
When disposing of the curtain shield airbag assembly, never use the customer's vehicle to deploy the airbag.
-
Be sure to follow the procedure detailed below when deploying the airbag.
HINT:
Prepare a battery as the power source to deploy the airbag.
(a) Check the function of the SST See: Steering Pad/Disposal.
(b) Remove the curtain shield airbag assembly See: Removal.
CAUTION:
When removing the curtain shield airbag assembly, work must be started 90 seconds after the engine switch is turned off and the negative (-) terminal
cable is disconnected from the battery.
(c) Cut off the deployment section of the curtain shield airbag assembly.
(d) Using a service-purpose wire harness for the vehicle, tie down the curtain shield airbag assembly to the tire.
