GS 460 V8-4.6L (1UR-FSE) (2008)
/Page-1694010.png)
(a) Remove the STARTER relay from the engine room No. 1 relay block.
(b) Disconnect the starter connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (STARTER RELAY - STARTER ASSEMBLY)
OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR (STARTER - BATTERY)
17. CHECK HARNESS AND CONNECTOR (ST CUT RELAY - POWER SOURCE CONTROL ECU)
(a) Remove the ST CUT relay from the engine room No. 2 relay block.
(b) Disconnect the power source control ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
