GS 460 V8-4.6L (1UR-FSE) (2008)
(e) Check if steering unlock command reception is confirmed.
OK:
"YES" is displayed on the Techstream display.
NG -- CHECK SMART ACCESS SYSTEM WITH PUSH-BUTTON START
OK -- Continue to next step.
3. INSPECT STEERING LOCK ACTUATOR ASSEMBLY
(a) Measure the voltage according to the value(s) in the table below.
Voltage:
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG -- Continue to next step.
4. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND)
(a) Disconnect the K28 connector from the steering lock actuator assembly.
(b) Measure the resistance according to the value(s) in the table below.
Resistance:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - POWER SOURCE CONTROL ECU)