GX 470 V8-4.7L (2UZ-FE) (2004)
D.
Remove the two (2) bolts disconnect the motor connector and then remove the gear assembly.
2.
Remove the roof wind deflector.
A.
Using a flathead screwdriver hold down the guide block release lever and push the plastic clip forward.
B.
Slide the guide block backwards and out. Repeat for the other side and remove the wind deflector.
NOTE
To prevent breakage of the guide block release lever when the outside temperature is below 40° F (4° C), use a heat gun to raise the
temperature of the guide block and surrounding aluminum housing to at least 65° F (18° C). Be careful NOT to damage components or
paint with the heat gun.
3.
Disconnect the wind deflector rod.
A.
Place a screwdriver against the rail in the notch area as shown in the illustration and pry the rod to disconnect it.