GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-947004.png)
d) Remove the 4 nuts and pull out the brake master cylinder.
13. REMOVE BRAKE BOOSTER GASKET
a) Remove the brake booster gasket from the brake master cylinder.
14. FIX BRAKE MASTER CYLINDER
a) Using SST, set the brake master cylinder in a vise.
SST 09630-00014 (09631-00142), 09950-60010 (09951-00180, 09951-00190)
15. REMOVE MASTER CYLINDER PUSH ROD CLEVIS
a) Loosen the lock nut on the brake master cylinder side then remove the rod operating adapter and lock nut.
b) Loosen the lock nut on the rod operating adapter then remove the push rod clevis and lock nut.
16. REMOVE MASTER CYLINDER BOOT
17. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
a) Using a clip remover, remove the brake level warning connector from the brake actuator bracket No.1.
b) Remove the 3 screws and pull out the master cylinder reservoir sub-assembly.
18. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY
19. REMOVE MASTER CYLINDER RESERVOIR GROMMET
a) Remove the 3 reservoir grommets from the master cylinder reservoir sub-assembly.
20. REMOVE BRAKE MASTER CYLINDER KIT
a) Pressing the brake master cylinder plug in with a screwdriver, use a pin or equivalent to push the snap ring from the hole in the master cylinder
body and then remove it with another screwdriver.
b) Remove the brake booster piston, brake booster plug and master cylinder piston by pulling straight out, not at angle.
NOTICE: If pulled out at an angle, there is a possibility that the cylinder bore could be damaged.
