GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-1269021.png)
44.
Install the brackets to the condenser and install the condenser assembly to the vehicle.
A.
Install the 4 condenser brackets to the condenser.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
NOTE:
Install the brackets removed in step 23.
B.
Install the condenser assembly to the vehicle.
Remove Interior Parts
PRECAUTIONS & COMPLIANCE WITH MOUNTING PARTS:
^
Do NOT reuse damaged clips, bolts, and nuts.
^
Make sure that all clips, bolts, and nuts have been installed.
^
Be careful to NOT stain parts or the body with compressor oil when replacing the A/C pipe, etc.
^
Be sure there are NO oil or A/C gas leaks after installation.
^
Be sure to connect all wire connectors.
^
Make sure that there is NO interference between the pipes, etc.
^
Make sure that the A/C works properly after installing all parts.
^
Make sure that there is NO damage on the surface of the pipe or hose.
^
Make sure that there is NO damage or foreign matter on the 0-ring or the connecting portion.
^
When installing to the pipe, apply oil to the 0-ring before connecting to prevent damage. (Compressor oil - ND-OIL8)
^
Do NOT reuse old adhesive tape.
^
Do NOT use the damaged seals/O-rings.
