GX 470 V8-4.7L (2UZ-FE) (2004)
^
Do NOT reuse the pipe and seal that was removed from step 20 of the "Remove exterior parts" section of the Repair Procedure.
^
Using the scraper (or equivalent), remove the remaining seal.
27.
Connect the wire harness to the NC pressure switch by engaging the wire harness clip.
28.
install the A/C cooler refrigerant suction hose sub-assembly.
A.
Put the suction hose in from the lower side.
B.
Temporarily install the suction hose to the compressor.
C.
Install the nut on the A/C cooler refrigerant suction hose sub-assembly (compressor side) from the upper cover in the left wheel well.
Torque: 9.8 N.m
(100 kgf.cm, 87 in.lbf)