GX 470 V8-4.7L (2UZ-FE) (2004)
/Page-308047.png)
57.
Connect the negative (-) battery cable.
Install Hood Seal
PRECAUTIONS & COMPLIANCE WITH MOUNTING PARTS:
^
Do NOT reuse damaged clips, bolts, and nuts.
^
Make sure that all clips, bolts, and nuts have been installed.
^
Be careful to NOT stain parts or the body with compressor oil when replacing the A/C pipe, etc.
^
Be sure there are NO oil or A/C gas leaks after installation.
^
Be sure to connect all wire connectors.
^
Make sure that there is NO interference between the pipes, etc.
^
Make sure that the A/C works properly after installing all parts.
^
Make sure that there is NO damage on the surface of the pipe or hose.
^
Make sure that there is NO damage or foreign matter on the 0-ring or the connecting portion.
^
When installing to the pipe, apply oil to the 0-ring before connecting to prevent damage. (Compressor oil - ND-OIL8)
^
Do NOT reuse old adhesive tape.
^
Do NOT use the damaged seals/O-rings.
HINT:
^
To prevent damage to the outer panel of the hood, wrap tape on the drill bit as shown so that ONLY 10 mm (0.39 in.) of the bit is exposed. Be
sure to apply the rust prevention treatment to the drilled holes.
