GX 470 V8-4.7L (2UZ-FE) (2004)
Tire Pressure Sensor: Service and Repair
Tire Pressure Monitor Receiver Assembly
TIRE PRESSURE MONITOR RECEIVER ASSEMBLY (From November, 2003)
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE REAR NO.2 SEAT ASSEMBLY LH
3. REMOVE REAR NO.2 SEAT ASSEMBLY RH
HINT: Remove the RH side following the same procedures as with the LH side.
4. REMOVE ROOF HEADLINING ASSEMBLY
5. REMOVE TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
(a) Disconnect the connector.
(b) Remove the 2 bolts and receiver assembly.
6. INSTALL TIRE PRESSURE MONITOR RECEIVER ASSEMBLY
(a) Install the receiver assembly with the 2 bolts.
Torque: 6.8 Nm (69 kgf-cm, 60 in.-lbf)
(b) Connect the connector.
7. INSTALL ROOF HEADLINING ASSEMBLY
8. INSTALL REAR NO.2 SEAT ASSEMBLY LH
9. INSTALL REAR NO.2 SEAT ASSEMBLY RH
HINT: Install the RH side following the same procedures as with the LH side.
10. CONNECT BATTERY NEGATIVE TERMINAL
11. INSPECT TIRE PRESSURE WARNING SYSTEM
SST 09843-18040