GX 470 V8-4.7L (2UZ-FE) (2004)
CAUTION:
-
When removing the instr pnl pass l/door airbag assy, work must be started 90 seconds after the ignition switch is turned to the "LOCK"
position and the negative (-) terminal cable is disconnected from the battery.
-
Store the instr pnl pass l/door airbag assy with the airbag deployment side facing upward.
b. Using a service-purpose wire harness for the vehicle, tie down the instr pnl pass l/door airbag assy to the tire.
Wire harness: Stripped wire harness section 1.25 m.sq.m or more (0.0019 sq.in or more)
CAUTION:
If a wire harness which is too thin or some other thing is used to tie down the instr pnl pass l/door airbag assy, it may be snapped by the shock
when the airbag is deployed. This is highly dangerous. Always use a wire harness which is at least 1.25 m.sq.m (0.0019 sq.in).
HINT: To calculate the square of the stripped wire harness section:
Square 3.14 x sq.(Diameter) divided by 4
Position the instr pnl pass l/door airbag assy inside the tire with the airbag deployment side facing inside.
Tire size: Must exceed the following dimensions
Width: 185 mm (7.28 in.)
Inner diameter: 360 mm (14.17 in.)
CAUTION:
-
Make sure that the wire harness is tight. It is very dangerous if looseness in the wire harness results In the instr pnl pass l/door airbag assy
coming free due to the shock from the airbag deploying.
-
Always tie down the instr pnl pass l/door airbag assy with the airbag deployment side facing Inside.
NOTE: The tire will be marked by the airbag deployment, so use a redundant tire.