GX 470 V8-4.7L (2UZ-FE) (2004)
Air Bag: Service and Repair
Steering Wheel Pad and Spiral Cable
Replacement
REPLACEMENT
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE STEERING WHEEL COVER LOWER NO.2
a. Using a screw driver, remove the steering wheel cover lower No.2.
4. REMOVE STEERING WHEEL COVER LOWER NO.3
a. Using a screw driver, remove the steering wheel cover lower No.3.
5. REMOVE HORN BUTTON ASSY
a. Place the front wheels facing straight ahead.
b. Using a torx socket wrench (T30), loosen the 2 torx screws until the groove along the screw circumference catches on the screw case.
c. Pull out the horn button assy from the steering wheel assy and support the horn button assy one-handed as shown in the illustration.
NOTE: When removing the horn button assy, take care not to pull the airbag wire harness.
d. Using a screwdriver, disconnect the airbag connectors.
e. Disconnect the horn connector.
f.
Remove the horn button assy.
6. INSTALL HORN BUTTON ASSY