GX 470 V8-4.7L (2UZ-FE) (2004)
Seat Belt: Service and Repair
Removal and Installation
Replacement
REPLACEMENT
-
The installation is in the reverse order of the removal. However, when there is a special point concerning the installation, it is indicated.
-
On the LH side, use the same procedures as on the RH side.
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT SEAT ASSY
3. REMOVE FRONT SEAT INNER BELT ASSY RH
a. Remove the nut and inner belt.
4. REMOVE FRONT DOOR SCUFF PLATE RH
5. REMOVE COWL SIDE TRIM BOARD RH
6. REMOVE QUARTER SCUFF PLATE INNER RH
7. REMOVE REAR DOOR SCUFF PLATE RH
8. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH
10. REMOVE CENTER PILLAR GARNISH LOWER RH
11. REMOVE CENTER PILLAR GARNISH RH
12. REMOVE FRONT SEAT OUTER BELT ASSY RH
NOTE:
-
Removal operation concerning the seat belt with the pretensioner must be started when 90 seconds or more have passed after the ignition
switch is turned OFF and the battery negative terminal is disconnected.
-
Carefully read the notices for the "pretensioner" in the SRS airbag system section and the front seat outer belt assy section.
a. Remove the nut and the outer belt on the shoulder anchor side.
b. Disconnect the pretensioner connector, as shown in the illustration.
c. Disconnect the tension reducer connector.
d. Remove the 2 bolts on the retractor side and throughly remove the outer belt assy.
13. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSY
a. Remove the bolt and anchor adjuster assy.
14. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSY
a. Install the adjuster assy with the bolt.
Torque: 42 Nm (420 kgf.cm, 31 ft.lbf)
15. INSTALL FRONT SEAT OUTER BELT ASSY RH
NOTE: Do not disassemble the retractor.