GX 470 V8-4.7L (2UZ-FE) (2004)
Impact Sensor: Service and Repair
Airbag Front RH Sensor
REPLACEMENT
1. PRECAUTION
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE RADIATOR SUPPORT SEAL UPPER
4. REMOVE AIR BAG FRONT RH SENSOR
a. Remove the bolt and airbag front RH sensor.
b. Disconnect the connector from the airbag front RH sensor.
5. INSPECT AIR BAG FRONT RH SENSOR
6. INSTALL AIR BAG FRONT RH SENSOR
a. Check that the ignition switch turn OFF.
b. Check that the battery negative terminal is disconnected.
NOTE: Do not start the operation for 90 seconds alter removing the terminal.
c. Install the airbag front RH sensor with the bolt.
Torque: 7.5 Nm (76 kgf.cm, 66 in.lbf)
d. Connect the connector to the airbag front RH sensor.
e. Check that no play is identified.
7. INSPECT SRS WARNING LIGHT