GX 470 V8-4.7L (2UZ-FE) (2004)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Rear
SPEED SENSOR REAR LH
REPLACEMENT
HINT: Replacement of RH side is same as that of LH side.
1. REMOVE REAR WHEEL
2. REMOVE SPEED SENSOR REAR LH
a) Disconnect the speed sensor connector.
b) Remove the nut and speed sensor rear from the axle hub.
NOTICE:
^
Do not stick a foreign matter on the sensor tip.
^
Do not let the foreign matter into the sensor installation hole.
3. INSTALL SPEED SENSOR REAR LH
a) Install the rear speed sensor with the nut to the steering knuckle.
Torque: 8.3 Nm (85 kgf-cm, 73 inch lbs.)
NOTICE: Make sure the sensor tip is clean.
b) Connect the speed sensor connector.